DC Slim Collet (DC-4/6)

- Material: SUJ2
-Powerful Clamping
- Clamping precision is high
- 5.72 degree cone angle design, the clamping power is up to 2 times
Than ordinary ER Collet
- the built-in collet design, and the clamping action is on the head
Of collet, both contributing to the stable clamping and high precision
Clamping(0.005mm)
- The locking system is directly tightened at the bottom, it is more
Suitable for the high speed processing than use a nut for locking.
- The EC collet uses a direct connection at the bottom and the
Clamping action is on the head of the collet. So clamping is more
Stable than on traditional ER collets and the accuracy can be
Maintained within 0.005mm.

Assembling Instructions
Insert groove of collet into eccentric ring of the
Clamping nut at the mark on the bottom of the
Nut. Push collet in the direction of the arrow
Until it clicks in place. Screw nut with collet onto
Toolholder. We recommend to tighten the nut
With a torque wrench.
Disassembly Instructions
After the nut is unscrewed from the toolholder,
Press on the face of the collet while
Simultaneously pushing sideways on the back of
The collet opposite the mark until it disengages
From the clamping nut.